29
2020
-
10
Hotel furniture manufacturer: Different materials for custom hotel furniture result in different installation methods.
Hotel furniture manufacturers: The installation of custom-made hotel furniture is not something everyone can do; it requires professional technicians. The hotel furniture structure must also be designed according to the actual situation in the early stages. However, not everyone is a professional, so they cannot directly decide on the structural design.
Hotel furniture manufacturer ： Custom hotel furniture Installation is not something everyone can do; it requires professional technicians. The hotel furniture structure must also be designed according to the actual situation in the early stages. However, not everyone is a professional, so the structural design cannot be directly determined.
Custom hotel furniture Different material installation methods
1. Wall panel installation:
This panel can only be installed 3 days after disassembly and packaging. When fixing the battens, it is necessary to use sufficient screws, and the exterior cannot be used as a wooden washer. The interacting slabs should be set in a humid house, and the exterior panel should be at a right angle to the decorative panel. If necessary, wooden washers should be used at the fixing points to strengthen the slabs, which also helps to level.
The shim material should be located between the panels of the base frame. When decorating a seamless connecting wall, it is easier to install from the corner. If the wall is irregular (vertical arrangement), use a full-size decorative panel to start installation from the door and window, and cut the panel to the required size after reaching the corner.
A space of about 10 mm should always be left between the decorative panel and the floor or top surface, and at least 20 mm between the ceiling decorative panel and the wall, to facilitate airflow. The tenon on the other side of the wall is fixed, and fixed with small nails on the slab, and (bubble) alcohol board is installed.
In addition, round galvanized nails can be used to fix the decorative panel. Place the fixing clip in the exposed tenon, nail it to the board on the chassis, and introduce the corresponding edge of the next panel into the fixing clip and tenon of the front panel. If the panel is too short, it is necessary to cut them to the appropriate size and create a pair of joints, and then use the panel to compensate for the previous pair of joints.
2. Installation of medium-density fiberboard:
Medium-density fiber wall panels, with medium-density fiber as the base material, after decorative layer treatment, the surface shows a high-level imitation wood painting or high-end furniture film with a fashionable artistic style, and can also be made into a large number of other decorative paintings.
In addition, the decorative panel chamfer patterns are constantly changing, such as right-angle corners, round edges, S-shaped edges, groove edges, etc., and there are some indispensable accessories, such as special clamping screws, cover plates, Yinyang corner, skirting boards, etc. MDF wall panels are mainly 2600 mm 150 mm.
3. Installation of custom solid wood wall panels for hotels:
Solid wood wall panels are made by direct drying treatment of birch, linden, sweater, pine, etc. It has the advantages of insect prevention, decay prevention, and simple construction.
Hotel furniture manufacturer The general standard of solid wood panels is as follows: (thickness) (8-20) mm × (width) 65 mm × (length) (100-4000) mm, (8-20) mm × 85 mm × (100-4000) mm and (8-20) mm × 95 mm × (100-4000) mm, and can also be customized according to user requirements.
Keyword: Hotel Furniture
Hotel furniture manufacturer, custom hotel furniture
Follow Us
Contact Us
Fax: +86-757-26331008
Website: www.gdtongda.com / www.经典通达.cn
Address: Chayong Industrial Zone, Beijiao Town, Shunde District, Foshan City, Guangdong Province